IBM CATE C4040-109

일년무료 업데이트 서비스 제공

C4040-109덤프는 IT업계에 오랜 시간동안 종사하셨던 베테랑 전문가들이 오랜 시간동안 쌓아온 풍부한 경험과 IT지식으로 만들어낸 최고의 제품입니다. C4040-109덤프자료는 적중률 높은 전면적인 덤프임으로 여러분은 한번에 C4040-109시험을 패스하실수 있습니다. C4040-109덤프를 구매하시면 덤프유효성을 연장해드리도록 1년무료 업데이트 서비스를 제공해드립니다.

IT업계 엘리트한 강사들이 퍼펙트한 C4040-109시험자료 덤프문제집을 제작하여 디테일한 시험문제와 답으로 여러분이 아주 간단히 C4040-109인증시험을 패스할 수 있도록 최선을 다하고 있습니다.

덤프는 세가지 버전으로 제공가능

C4040-109시험덤프는 3개 버전으로 되어있는데PDF버전은 출력하여 어디에서든 공부가능하고 소프트버전과 온라인버전은 PDF버전의 내용과 동일한데 PDF버전 공부를 마친후 실력테스트 가능한 프로그램입니다. C4040-109덤프의 소프트웨어버전은 PC에 JAVA시스템을 설치하면 작동가능하고 IBM CATE온라인버전은 PC뿐만아니라 휴대폰에서도 사용가능하기에 소프트웨어버전을 업그레이드한 버전이라고 보시면 됩니다.

인증시험을 쉽게 패스하는 방법

C4040-109시험은 IT업종에 종사하시는 분들께 널리 알려진 유명한 자격증을 취득할수 있는 시험과목입니다. C4040-109시험은 영어로 출제되는 만큼 시험난이도가 많이 높습니다.하지만 C4040-109인증덤프만 있다면 아무리 어려운 시험도 쉬워집니다. 오르지 못할 산도 정복할수 있는게 저희 제품의 우점입니다. C4040-109덤프로 C4040-109시험을 패스하여 자격증을 취득하면 정상에 오를수 있습니다.

IBM C4040-109 시험 요강 주제:

최신 CATE C4040-109 무료샘플문제

1. An administrator is configuring a new virtual Fibre Channel connection that will use NPIV to connect a client LPAR to a SAN.
The administrator has created a client adapter in virtual slot 8 and a server adapter in virtual slot 600. The appropriate virtual adapter definitions have been successfully added into the client and VIO server profiles and a DLPAR operation to add the virtual adapters into both partitions.
The administrator runs cfgmgr on the client partition but receives an error. The administrator then checks the definition of the client adapter in AIX Based on this information, what is the most likely cause of the error?

A) The virtual Fibre Channel server adapters are not supported with virtual slot numbers higher than 512.
B) The virtual Fibre Channel device driver has not been installed on the client.
C) The virtual server adapter has been incorrectly mapped to virtual slot 3 for the client.
D) The virtual server adapter has not been mapped to a physical Fibre Channel adapter.

2. An administrator would like to determine the virtualization capabilities of some attached storage before proposing a new virtualization strategy. To determine the capabilities of the attached storage, the administrator runs chkdev and receives the following result:
padmin:vio1:/home/padmin>chkdev -dev hdisk1 NAME: hdisk1 IDENTIFIER: 382136005076801710072480000000000791F04214503IBMfcp PHYS2VIRT_CAPABLE: NA VIRT2NPIV_CAPABLE: YES VIRT2PHYS_CAPABLE: YES
Based on the output above, which one of the statements is true?

A) The disk can be converted to NPIV with data loss.
B) The disk can only be presented as a physical disk.
C) The disk can be presented by NPIV only.
D) The disk is presented by vSCSI and is NPIV capable.

3. An administrator uses DLPAR on an active LPAR to add an additional VLAN ID into an existing virtual adapter used by the SEA. The operation fails with error HSC01221 stating that the Modification of Virtual I/O resources failed. The server being modified is a POWER6 595 running firmware version EH350_071. The VIO Server is at version 2.2.0.10 FP24Based on this information, what is the most likely cause for this error?

A) Dynamic addition of VLAN IDs to an existing virtual adapter are only supported on POWER7 hardware.
B) The VIO Server needs to be updated to 2.2.0.10 FP 24 SP1.
C) The system firmware needs to be updated to EH350_085.
D) Dynamic addition of VLAN IDs to an existing virtual adapter are only supported at AIX
7.1.

4. An administrator is designing a new system. Redundancy is critical, and cost must be kept as low as possible.
The system planned is a Power 770 with 2 enclosures, each with a 10Gb IVE. It will support 6 dedicated production LPARs, 8 development LPARs, and 2 VIO Servers.
Production and development networks must be separate from each other.
Which of the following network solutions supports the requirements above?

A) Use dedicated Ethernet cards in each Production LPAR using Ether channel Allocate two dedicated Ethernet cards to the VIO Servers Create a SEA and use for development LPARs
B) Allocate Integrated Virtual Ethernet adapters ports to the VIO Servers Configure a Shared Ethernet Adapter for production and another for development Allocate virtual network devices to LPARs
C) Utilize the Integrated Virtual Ethernet adapter in each enclosure Allocate 1 logical port from each IVE in each enclosure to each LPAR and VIO Server Configure 802.1Q on each LPAR
D) Run dedicated adapters in the VIO Servers Configure a Shared Ethernet Adapter for production and another for development Allocate virtual network devices to LPARs.

5. A VIO server administrator is configuring MPIO-based storage for a new LPAR named P7_3_AIX.The administrator runs the lspv -free command and sees 4 disks free. The lsmap -all command confirms that the disks are free. A check of the list of LPARs shows the following: In order to avoid problems, what else should be verified before mapping storage to the new LPAR?

A) That the free disks are MPIO capable
B) If the free disks are allocated to P7_2_AIX
C) That the free disks are allocated to a shared storage pool
D) If the free disks are allocated to P7_3_AIX

질문과 대답: